PRTCZECX01A
ECOVEXX for Bleaching powder Application Guide
Materials Needed:
- Bleaching Powder
- Peroxide (appropriate volume)
- Ecovexx Xsence N°1
- Mixing bowl and brush
- Measuring cup
- Gloves
- Timer
- Xsaver N°2
- Flexion (L) brush
Preparation:
- Mix the bleaching powder with the required amount of peroxide according to standard practice.
- Incorporate 2 ml of Xsence N°1 for every 10 grams of bleaching powder used.
- Combine until the mixture is smooth and free of lumps.
Application:
- Apply the blend to dry, unwashed hair, starting at the back and progressing towards the front. Take care to avoid direct scalp application for non-scalp bleaches.
- Partition hair using sectioning clips to ensure even coverage.
- Regularly check the hair at intervals of 5-10 minutes to monitor the lifting process.
- Adhere to the maximum processing time as recommended.
Finishing:
- Upon reaching the desired lift, thoroughly rinse hair with tepid water.
- Gently shampoo to cleanse out all traces of the bleaching agent.
- Towel-dry hair and distribute Xsaver N°2 evenly, leaving it on for a minimum of 5 minutes.
- Rinse off thoroughly and apply a nourishing deep conditioner if necessary.
- Detangle and smooth the hair using the Flexion (L) brush.
Post-Treatment Advice:
- Suggest avoiding hot water for hair washes in the following 48 hours.
- Recommend the Code Zero Focus product line for ongoing hair care.
- Advise minimal use of heat styling tools to prevent additional hair stress.